Register A People Counting Sensor
Register your people counting sensors to the Yeastar Workplace, so that the devices can interact with the system.
Tip
All the devices are registered to the system via the device Serial Number. Collect the devices‘ SN before you start the registration.
Prerequisites
Supported model: Milesight VS121
- Yeastar Workplace plan: Pro Plan.
- At least one of your LoRaWAN gateways is registered to Yeastar Workplace. For more information see register a LoRaWAN gateway.
Procedure
-
Log in to Yeastar Workplace management portal.
-
Go to Device Management > Device List, click Add.
-
In the pop-up window, enter the device SN, specify a name, and select a gateway.
If the SN is correct, the system automatically detects the device type.
Best practice
Specify a name that can help you identify where the device will be located, and also stick a small note on the back of the device. This is an operation that can help you manage multiple devices efficiently.
-
Click OK.
-
Power on the device or reboot the device.
Result
The status on the screen indicates that the device is registered to Yeastar Workplace.
After the sensor is bound to a meeting room, you can view the data collected by the People Counting Sensor in the following ways:
- Log in to Yeastar Workplace, and on the Meeting Room Booking page, click the meeting room that the sensor is bound to.
- In the upper right corner of the Room Display screen, view the data collected by the People Counting sensor.
Related topics
Install your people counting sensors.
Created: December 16, 2021
Author: carol