Basic Network Overview

This topic describes the network modes in Yeastar P-Series Software Edition.

Ethernet modes

Yeastar P-Series Software Edition provides LAN interface and WAN interface. By default, the LAN interface is enabled, and the WAN interface is disabled. You can configure the following Ethernet modes for the system:
Note: For the PBX that is installed on a cloud server (e.g. Amazon AWS), only Single mode is supported.
  • Single: Only LAN port is used for connection, WAN port is disabled.
  • Dual: Both LAN port and WAN port are used for connection.
    If you use Dual mode, you need to specify a default network interface for the PBX.
    Note: The traffic will be routed to the default interface, you need to add a static route to override the default route entries, routing the traffic from a specific IP address to the specified destination.

Internet protocols

Yeastar P-Series Software Edition supports the following Internet protocols:
  • IPv4 only: The PBX can be configured with IPv4 address, and can communicate with the devices that support IPv4 protocol.
  • IPv4 / IPv6 dual stack: The PBX can be configured with both IPv4 address and IPv6 address, and can communicate with a wide range of devices that support IPv4 protocol or IPv6 protocol.

IP address assignment

Yeastar P-Series Software Edition supports three types of IP address assignment:
Note: For the PBX that is installed on a cloud server (e.g. Amazon AWS), IP address can only be obtained from a DHCP server.
  • Assign a static IP address

    Contact your network administrator to assign an IP address to the PBX. Then you need to manually configure settings such as the IP address, subnet mask, default gateway, and DNS servers on the PBX.

  • Obtain an IP address from a DHCP server

    You can configure the PBX to automatically obtain an IP address when it starts up from a DHCP server running in your network.

    Note: The IP address assigned to the PBX may vary every time the PBX is started up.
  • Obtain an IP address from a PPPoE client

    You can connect the PBX to a PPPoE client, and set up a PPPoE connection on the PBX to get an IP address.

    Note:
    • The IP address assigned to the PBX may vary every time the PPPoE is started up.
    • IPv6 over PPPoE is NOT supported.