Set up SNMP on Yeastar P-Series Software Edition
This topic describes how to enable SNMP and configure the related settings on Yeastar P-Series Software Edition.
Requirements
The version of Yeastar P-Series Software Edition is 83.17.0.60 or later.
Procedure
- Log in to PBX web portal, go to .
- In the Basic section, set up SNMP related settings
that required when adding the monitored device to the NMS.
- Turn on SNMP.
- Complete the following settings.
Setting Description SNMPv3 Username Enter a user name for authentication on NMS. Authentication Mode Select an authentication method. - NoAuth: Provide access control based on the user name.
- Auth: Provide access control based on the HMAC-MD5 authentication.
- Priv: Provide access control based on the HMAC-MD5 authentication and data encryption by CBC-DES.
Auth Password Retain the default authentication password, or enter a desired password. Note: This option is available only when Authentication Mode is set to Auth or Priv.Encrypted Password Retain the default encryption password, or enter a desired password. Note: This option is available only when Authentication Mode is set to Priv.Port Retain the default SNMP port 161
, or enter a desired port number.
- Optional: To enable the PBX to send SNMP trap messages to NMS when a
pre-defined event occurs and triggers the trap, set up SNMP trap.
- Turn on SNMP Trap.
- Enter the IP address of the SNMP trap receiver and the port to which the SNMP traps will be sent.
- Click Save.
Result
The SNMP feature on Yeastar P-Series Software Edition is set up.
What to do next
Connect Yeastar P-Series Software Edition with Network Management System (NMS) via
SNMP.
Note:
- Enter the IP Address of your PBX on NMS, instead of the Yeastar FQDN (Fully Qualified Domain Name).
- We provide an example on how to connect Yeastar P-Series Software Edition with Zabbix Server. For more information, see Monitor Yeastar P-Series Software Edition through SNMP using Zabbix Server.