Create a SIP Account Trunk
A SIP Account is used for the other device to register with Yeastar P-Series Software Edition. In this way, Yeastar P-Series Software Edition and the other device are connected. This topic describes how to create a SIP Account Trunk on Yeastar P-Series Software Edition.
Prerequisites
To connect a third-party device with Yeastar P-Series Software Edition by a SIP Account Trunk, you need to make sure that there is no duplicate extension numbers on both sides.
Procedure
- Log in to PBX web portal, go to Add. , click
- In the Basic section, configure the following settings:
- Name: Enter a name to help you identify it.
- Trunk Status: Select Enabled.
- Select ITSP Template: Select General.
- In the Detailed Configuration section, configure the
following settings:Note: You can leave the default SIP information or edit the information according to your needs.
Setting Description Trunk Type Select Account Trunk. Transport Select a transport. The following options are supported: - UDP
- TCPNote: By default, SIP TCP port is disabled. If you select this option, go to , enable SIP TCP Port, then reboot the PBX to make it take effect.
- TLS
Username Enter a username for the SIP account. Password Enter a password for the SIP account. Authentication Name Retain the default authentication name or enter a custom one. Note: If the device to be connected does NOT support the Authentication Name field, select Use User Name as Account Trunk's Authentication Name. - Optional: Click Advanced, Inbound Caller ID Reformatting, Outbound Caller ID, or SIP Headers to configure other settings.
- Click Save and Apply.
What to do next
-
Register the SIP Account Trunk on the third-party software or device. Depending on the network of the third-party software or device, you need to provide different information:
- Same local network as Yeastar P-Series Software Edition
- SIP Account Trunk details
- Local IP address of PBX
- Local SIP port of PBX
- Different network from Yeastar P-Series Software Edition
- SIP Account Trunk details
- Public IP address, External host domain name, or
FQDN domain name of PBXNote:
- If the account trunk uses public IP address or
external host domain name, you need to configure
the network and port forwarding first.
For more information, see Configure Network for Remote Access by a Public IP Address or Configure Network for Remote Access by a Domain Name.
- If the account trunk uses FQDN, make sure this
account trunk can perform remote SIP registration
via FQDN.
For more information, see Configure Network for Remote SIP Access by a Yeastar FQDN.
- If the account trunk uses public IP address or
external host domain name, you need to configure
the network and port forwarding first.
- External SIP port of PBX
- Same local network as Yeastar P-Series Software Edition
- To receive inbound calls through the trunk, you need to select this trunk to one or more inbound routes. For more information, see Set up an Inbound Route.
- To make outbound calls through the trunk, you need to select this trunk to one or more outbound routes. For more information, see Set up an Outbound Route.
Result
Go to
to check the trunk status on the trunk list page.If the SIP Account Trunk is successfully registered on the third-party software or device, the trunk status will show , which also indicates that the two devices are connected.
For more information of SIP trunk status, see SIP Trunk status.