Create a SIP Trunk from a Template

Yeastar has tested leading ITSP across the globe and provides configuration templates for the tested and certificated ITSP. If a template is provided for your ITSP on the PBX, you can quickly create a SIP Trunk by the template.

Prerequisites

  • Check if your ITSP is tested and supported by Yeastar from ITSP partner page.
  • Your PBX can connect to the ITSP.

Procedure

  1. Log in to PBX web portal, go to Extension and Trunk > Trunk, click Add.
  2. In the Basic section, configure the following settings:
    • Name: Enter a name to help you identify it.
    • Trunk Status: Select Enabled.
    • Select ITSP Template: Select your country.
    • ITSP: Select your ITSP.

    The trunk details are displayed automatically in the Detailed Configuration section.

    • If the trunk type is displayed as Register Trunk, configure the following settings:
      • Username: Enter the username provided by the ITSP.
      • Password: Enter the password provided by the ITSP.
      • Authentication Name: Optional. Authentication name is used for SIP authentication. If the ITSP provides an authentication name, enter the name.
    • If the trunk type is displayed as Peer Trunk, leave the settings as default.
  3. Optional: If you have purchased DID numbers from the ITSP, click DIDs/DDIs tab to configure the DID numbers for the trunk.
    1. Click Add, then add DID number(s) according to your need.
      • To add a single DID number, do as follows:
        1. In the Create Method drop-down list, select Single DID.
        2. Configure the following settings:
        • DID/DDI: Enter the provided DID number.
        • DID/DDI Name: Optional. Enter a name to distinguish inbound calls by DID numbers.

          When the DID number is dialed, the name will be displayed on the called party's device.

      • To add a range of DID numbers, do as follows:
        1. In the Create Method drop-down list, select DID Range.
        2. Configure the following settings:
        • DID Range: Enter the start number and the end number of the DID range.
        • DID/DDI Name: Optional. Enter a name to distinguish inbound calls by DID numbers.

          When the DID number is dialed, the name will be displayed on the called party's device.

    2. Click Confirm.
    Note: For more information of DID configurations, see Configure DID Numbers on a Trunk.
  4. Click Save and Apply.

Result

Go to Extension and Trunk > Trunk to check the trunk status on the trunk list page.

If the status shows , the trunk is registered successfully.

For more information of SIP trunk status, see SIP Trunk status.

What to do next

  • To receive inbound calls through the trunk, you need to select this trunk to one or more inbound routes. For more information, see Set up an Inbound Route.
  • To make outbound calls through the trunk, you need to select this trunk to one or more outbound routes. For more information, see Set up an Outbound Route.