Select Outbound Caller ID (DOD) to Call

Before making outbound calls from Linkus, you can select which outbound caller ID (DOD) to display. You can use the same DOD number for all outbound calls or select a specific DOD for each call.

Requirements

  • PBX Server: 37.16.0.25 or later
  • Linkus Mobile Client: 5.6.6 or later
  • Extension: Your extension has been assigned the permission to select outbound caller IDs.

Methods of selecting DOD to call

By default, the DOD number configured by system administrator is used when you make outbound calls. You can choose to use the same DOD number for all outbound calls or select a specific DOD for each call.

  • Use the same DOD for all outbound calls: On the Dialpad, select a desired DOD number.

    Every time you make an outbound call using Dialpad, the DOD number will be used.
  • Select a specific DOD for each call: Select a desired DOD number before you make an outbound call.

    You can select a specific DOD number on the Dialpad, or from the Contacts, Call Logs, Voicemails, or Recordings page, as shown below.

    Page Instruction
    Figure 1. Contacts
    1. Go to Directory > Contacts, tap the desired contact.
    2. Long press .
    3. Tap Dial through PBX and Select DOD.
    4. Select the desired DOD number to call out.
    Figure 2. Call Logs, Voicemail, or Recordings
    1. Under Call Logs / Voicemail / Recordings tab, tap the desired record.
    2. Long press .
    3. Tap Dial through PBX and Select DOD.
    4. Select the desired DOD number to call out.