Access the System via SSH
This topic takes Putty as an example to introduce how to access Yeastar P-Series PBX System via SSH.
Procedure
- Enable SSH access on the PBX.
- Log in to PBX web portal, go to .
- Turn on the switch of SSH Access, then click
OK.
-
Check and note down the SSH credentials.
- Enter access information on Putty.
- In the Connection type field, choose SSH.
- In the Host Name (or IP address) field, enter your PBX's IP address.
- In the Port field, enter SSH port that you have configured on the PBX.
- Optional: On the left navigation bar, click , set a scrollback line number, so that you can get sufficient lines of log for debug analysis.
- Click Open.
- Verify your account and password.
- In the login as field, enter
support
. - In the password field, enter the password.
- In the login as field, enter
Result
If the following figure shows, you can successfully access and debug the PBX.