Log in to PBX Management Portal

Yeastar P-Series PBX System provides a web management portal that allows you to quickly set up and manage the system. This topic describes how to log in to PBX management portal.


  • You have connected the network cable.

    Select either of the following two methods to connect network cable.

    • Use a network cable to connect the LAN port of the PBX to the network adapter port of the PC.
    • Use a network cable to connect the LAN port of the PBX to a switch or a router, and also connect your PC to the switch or router.
  • An operation and maintenance terminal (a PC) is available. The PC must meet the following requirements:
    • Have a web browser installed and Chrome web browser is recommended.
    • Support the resolution of 1366 x 768 or higher.
  • You have set the IP address of your PC.

    The IP address of the PC must be on the same network segment as that of the PBX and cannot conflict with IP addresses of other devices.

    • The default IP address of Yeastar P-Series PBX System is, and the default gateway address is
    • If you fail to access the PBX management portal, contact your network administrator to check if your PC can communicate with the IP address


  1. Open the web browser, enter the IP address of the PBX (default: in the address bar, and press Enter.
    Note: If it is your first time to access the system, you will be redirected to the Installation Wizard.

    For more information of Installation Wizard, see Initial Setup Using the Installation Wizard.

  2. If a warning appears to remind you that the page is not secure, ignore the warning on the web page, expand the Advanced tab, and proceed to the PBX web.

  3. Enter the administrator username and password, click LOG IN.
    • Username: The username of administrator account that you have configured in the Installation Wizard.
    • Password: The password of the administrator account.