Receive Inbound Calls through the Extended FXO trunks

After connecting Yeastar P-Series Software Edition and Yeastar TA FXO gateway, you need to set up routes, so as to receive inbound calls through the extended FXO trunks.

Scenario

The application scenario is shown as the following figure.

Procedure

Step1. Create a 'Port->IP' route on Yeastar TA1610 gateway

On Yeastar TA1610 gateway, create a Port->IP route to route incoming calls to Yeastar P-Series Software Edition.
  1. Log in to gateway web interface, go to Gateway > Route Settings > Port->IP/Port, click Add Port->IP/Port Route.
  2. In the pop-up window, configure the route.

    • Simple Mode: Select Yes.
    • Route Name: Enter a name to help you identify it.
    • Call Source: Select the desired FXO trunk. In this example, select all FXO trunks.
    • Call Destination: Select the SIP trunk that is connected to Yeastar P-Series Software Edition. In this example, select the trunk SPS - p_series.
    • Hotline: Enter a hotline number. In this example, enter 123456.
      Note: The hotline number will be sent to the PBX as a DID number. In this way, incoming calls on the route will be sent to the PBX directly, eliminating the need of two-stage dialing.
  3. Click Save and Apply Changes.

Step2. Create an inbound route on Yeastar PBX system

On Yeastar P-Series Software Edition, create an inbound route to accept incoming calls from Yeastar TA1610 gateway.
  1. Log in to PBX web portal, go to Call Control > Inbound Route, click Add.
  2. Configure the following settings for the inbound route and leave other settings as default.
    • Name: Enter a name to help you identify it.
    • DID Pattern: Set up the DID pattern.
      • DID Matching Mode: Select DID Pattern.
      • Pattern: Enter the hotline number set on the TA1610 gateway, which is used to match the incoming calls from the gateway. In this example, enter 123456.

    • Trunk: Select the SIP peer trunk that is connected to the Yeastar TA1610 gateway. In this example, select the trunk Connect-to-TA1610-Gateway.

    • Default Destination: Select a destination for the inbound route.

      In this example, set the Destination to extension 2000. When incoming calls from TA1610 gateway reach the PBX, the calls will be routed to extension 2000.

  3. Click Save and Apply.

Step3. Make a test call to the FXO trunk

For example, the extended FXO trunk's number is 505523301, when users dial 505523301, the call will be routed to extension 2000 on the PBX.