Create a 4G Trunk
For 4G LTE module, you need to install in the specific module slot as the following table shows:
Note: Yeastar S-Series VoIP PBX
V4.0
does not support 4G Module (For Cellular Data).
PBX Model | 4G Module (For Cellular Data) | 4G Module (For Audio Calls) |
---|---|---|
S412 Lite | T_Slot3 | T_Slot3 or T_Slot4 |
S412 | T_Slot3 | T_Slot3 or T_Slot4 |
S20 | Slot1 | Any slot |
S50 | Slot1 | Any slot |
S100 | Slot1 on Expand Board 1 | Any slot |
S300 | Slot1 on Expand Board 1 | Any slot |
- Install 4G module.
- Power off the PBX.
- Open the upper case of the PBX.
- Place the 4G module above the main board, slowly insert each pin into right slot.
- Log in the PBX web interface, go to
If the trunk status shows the signal icon , or , the trunk is ready for use. For more information on trunk status, see 4G Trunk Status.
to check the trunk status. - Go to
- Name: Give this trunk a name to help you identify it.
- PIN Code: Enter the SIM card PIN code if the card has one.
- RX Volume: Set the receiving volume of GSM port or choose Custom to define the RX Gain below.
- TX Volume: Set the transmitting volume of GSM port or choose Custom to define the TX Gain below.
, configure the basic settings of the 4G trunk. - If you want to use cellular network of 4G module, click
Advanced tab, configure the
Mode.Note: Yeastar S-Series VoIP PBX V4.0 does not support cellular network.
- Voice and Data: can be used for both voice call and data access.
- Voice Only: can be used only for voice call.
- Configure other GSM/3G/4G Trunk Settings as your need.
- Click Save and Apply.