Integrate Yeastar P-Series PBX System with Hikvision Intercom Video Devices

This topic describes the integration of Hikvision intercom video devices with Yeastar P-Series PBX System, including the solution targets, test environment, and solution highlights. By configuring the Hikvision devices according to the introduction in this document, you can use the devices to make and receive phone calls similar to other IP phones, thus implementing door access control more easily.


This solution is tested with Hikvision devices that support SIP protocol. For Hikvision devices with the same model, SIP protocol may not be supported. For more information, contact your Hikvision account manager.

Supported Hikvision product models

Device Product Model
Hikvision Door Station DS-KD8003-IME1 (VIS_OUTDOOR_H11_EN_STD_V2.2.45_210430)
Hikvision Villa Door Station DS-KV8113-WME1(B), DS-KV8213-WME1(B), DS-KV8413-WME1(B) (VIS_VILLA_H11_EN_STD_V2.2.45_210430)
Hikvision Indoor Station DS-KH6320-WTE1, DS-KH6320-TE1 (VIS_INDOOR_R0_EN_STD_V2.1.20_build210420)


This integration guide introduces how to achieve communication between Hikvision door station and indoor station, and provides guidance on forwarding door station calls to Linkus clients. Follow the steps listed below to achieve the targets:

Network topology diagram

In this guide, the Hikvision devices and Yeastar P-Series PBX System are in the same local network. Check the test environment in the following table.

Device Firmware Version IP Address
Yeastar P570
Hikvision DS-KH6320 Indoor Station V2.1.10
Hikvision DS-KD8003 Door Station V2.2.3

The following figure is a schematic of device network connection.


By registering the Hikvision intercom video devices with Yeastar P-Series PBX System, you can achieve the following features:

  • Conduct real-time video communication with the visitor
    In addition to audio communication, the door station can conduct video communication with various endpoints.
    • Indoor station
    • Linkus Web Client
    • Video IP phone
  • Auto-forward visitor calls to your Linkus Mobile Client without missing any calls

    If you don't want to miss any calls when absent, you can configure the Call Forwarding feature, by which the calls will be forwarded to Linkus clients. In this way, remote access control can be easily implemented by Linkus clients.

  • Flexible access control with different endpoints

    You can answer and open the door from any Yeastar PBX extension endpoint (Linkus client or IP phone) anywhere, no matter you are in the office or on the road.