Provision Snom Phones with Yeastar S-Series VoIP PBX

This guide provides instructions on how to provision Snom phones with Yeastar S-Series VoIP PBX. The details in this guide takes Snom D745 running firmware as an example.

Supported phone models

  • 320, 710, 715, 720, 725, 760, 765
  • D120
  • D305, D315, D345, D375, D385
  • D712, D717, D715, D725, D735, D745, D765, D785
  • M215 SC
  • C520-WiMi

Factory reset the phone

Before provisioning the phone, you must reset the phone to factory defaults in case the device has residual settings of a previous configuration. To reset the phone, see How to Factory Reset Snom Phones.

Provision the phone via Plug’n’Play (PnP)

  1. Connect the phone to the same network of the Yeastar S-Series VoIP PBX.

    Make sure that the phone and PBX are located in the same network segment, and do not connect the network via VPN.

  2. Check the phones' MAC address and phone model, usually you can find them at the back of phone.
  3. Log in Yeastar S-Series VoIP PBX web interface, go to Auto Provisioning page, click Scan to scan phones in the local network.

    All the detected phones appear on the page.

  4. Find the phone from Device List, and then click .
  5. Assign an extension for the phone.

  6. Click Save.

    A pop-up dialog prompts you whether to reboot the phone immediately.

  7. Click Yes.

    The IP phone reboots automatically to get and apply configurations from the PBX.

  • If the IP phone doesn't reboot automatically, you need to reboot the phone manually to take effect.

  • Each time the IP phone reboots, it always gets the configurations from the PBX. In this case, the personal settings on the phone may be lost after the phone reboots.

Snom Provisioning options

In addition to provision phone lines, you can provision other phone settings to match your needs.

Note: Extended phone configurations vary on each phone model.
  • Function Key Settings

    Assign various functions to Function keys. This allows you to quickly access features and to view the monitored status when the Function keys are assigned with particular features (for example, BLF).

  • Features

    Enable or disable the phone features, such as Call Waiting, Auto Answer, Auto Redial, etc.

  • Preference

    Configure the phone preference settings, such as Language, Time Zone, Webserver Type, etc.

  • Codec

    Select and configure the preferred codec list for the phone.

    Note: At least one of the same codecs on the phone and the PBX is required, or there will be no audio in the call.