S50 Overview
Front Panel
LED | Indication | Status | Description |
---|---|---|---|
POWER | Power status | On | The power is switched on. |
Off | The power is switched off. | ||
SYSTEM | System status | Blinking | The system is running properly. |
Static/Off | The system goes wrong. | ||
1-8 LED (RJ11 port status) |
FXS | Green: static | The analog phone is idle. |
Green: blinking | The analog phone is busy. | ||
GSM/3G/4G | Red: static | The GSM/3G/4G Trunk is idle. | |
Red: blinking slowly | No SIM card. | ||
Red: blinking rapidly | The GSM/3G/4G trunk is in use. | ||
BRI | Orange: blinking | The BRI line is disconnected. | |
Orange: static | The BRI line is connected or in use. | ||
FXO | Red: static | The PSTN line is idle. | |
Red: blinking slowly | No PSTN line is connected to the FXO port. | ||
Red: blinking rapidly | The PSTN line is busy. | ||
Port | Description | ||
WAN/LAN |
Yeastar S50 provides two 10/100/1000Mbps adaptive RJ45 Ethernet ports, and supports 3 Ethernet modes. The default mode is “Single”.
|
||
SD | Insert SD card to store auto recording files. | ||
1-8 Port (RJ11 port) |
Note: The sequence number of the ports corresponds to that of
the Indicator lights in the front panel. (I.e. the LED
lights in the front indicate the connection status of the
corresponding ports at the back panel.)
|
||
Reset button | Press and hold for 10 seconds to restore the factory defaults. |
Rear Panel
Port | Description |
---|---|
Antenna Socket | Rotate the antenna into the Antenna Socket. |
Power Switch | Press this button to switch on/off the device. |
Power Inlet | Connect the supplied power supply to the port. |
Protective Earth | Connect to the ground to reduce the risk of electrocution to the user or protect the PBX from the bad effects of external noise in the case of a lightning strike. |