Replicate Settings of Outbound Route

This topic describes how to replicate settings of inbound rules (inbound routes) from 3CX to Yeastar Phone System.

Procedure

  1. View the existing outbound rules on 3CX Management Console.

    Go to Outbound Rules, and select an outbound rule to view its details.

  2. Create a new outbound route on Yeastar Management Portal.

    1. Go to Call Control > Outbound Route.
    2. Click Add.
  3. On Yeastar Management Portal, replicate the outbound route trigger settings from 3CX.
    1. In the Name field, copy the outbound rule name from 3CX.
    2. In the Dial Pattern section, replicate the outbound route trigger settings.
      • Pattern: Set the dial pattern according to 3CX's settings.
        • If a prefix is specified for Calls to numbers starting with prefix in 3CX, then enter the prefix and a ..

          For example, the prefix in 3CX is 9, then enter 9. on Yeastar Management Portal.

        • If a digit is specified for Calls to Numbers with a length of in 3CX, then enter the corresponding number of Xs.

          For example, the digit in 3CX is 7, then enter XXXXXXX on Yeastar Management Portal.

      • Strip and Prepend: Copy the settings from 3CX.
  4. On Yeastar Management Portal, copy the selection of extensions, extension groups, and trunks from 3CX.
    1. In the Trunk section, select the corresponding trunks.
    2. In the Extension / Extension Group section, select the corresponding extensions and extension group.
  5. Click Save and Apply.
  6. If there are multiple outbound rules in 3CX, repeat step 2~5.
  7. In the outbound route list, click to adjust the priority according to 3CX.