Register Vtech Phone with Yeastar K2 IPPBX

This guide is based on the Vtech VSP610A v2. 0. 3. 0 and Yeastar K2 IPPBX .

Note: For the IP phone with different firmware version, the web GUI may be different.

Configure the IP address via phone user interface

  1. Press System > Network > Basic Settings > Dual Mode > WAN Setting.
  2. Choose Static IP and alter the IP Address, Subnet Mask, Preferred DNS Server, Alternate DNS Server.
  3. Apply it after input the correct information.
  4. Reboot the phone and log in the phone web user interface using the new IP address.
  5. Enter the user name and password, click Log In to enter the web user interface.
    • User Name: admin
    • Default Password: admin

Account Registration

  1. Log in the IP phone, go to System > SIP Account Management, select one account to configure.
  2. Enable the account and fill in the extension information.

    • Enable Register: check

    • Account Label: The name you want to display on the phone screen.

    • Display Name: The name you want to display on another person's phone screen when you are calling the phone.

    • User Identifier: Enter the extension's Caller ID.

    • Authentication Name: Enter the extension's Registration Name.

    • Authentication Password: Enter the extension's Registration Password.

  3. In the SIP Server section and Registration section, fill in your PBX information.

    • SIP Server
      • Server Address: Enter the domain of your PBX.
      • Server Port: Enter the SIP port of your PBX.
    • Registration
      • Server Address: Enter the domain of your PBX.
      • Port: Enter the SIP port of your PBX.
  4. Click Apply.

    If the registration is successfully, the register status would show "Registered".