Add a Static Route

If you set the network mode of Yeastar K2 IPPBX to Dual, you need to add a static route to override the default route entries, routing the traffic from specific IP address to the specified destination.

  1. Go to Settings > System > Network > Static Routes > Static Routes, click Add.
  2. In the pop-up dialog box, configure the route entry according to the following information.
    • Destination: Enter the destination IP address or IP subnet for the PBX to reach using the static route.
    • Subnet Mask: Enter the subnet mask for the destination address.
    • Gateway: Enter the gateway address. The PBX will reach the destination address through this gateway.
    • Metric: Optional.

      Routing metric is used to determine whether one route should be chosen over another.

    • Interface: Select the network interface.

      The PBX will reach the destination address using the static route through the selected network interface.

  3. Click Save and Apply.
The static route is added to the routing table. Go to Settings > System > Network > Static Routes > Routing Table to check the routing table.