Auto Provision Phones by DHCP Method

Important: For the first time to auto provision your phones on the PBX, you need to RESET all your phones before auto provisioning, or auto provisioning may not work.
  1. Connect your phones to the same network of the PBX.
  2. Disable DHCP function on your router. Make sure that the Yeastar S-Series VoIP PBX is the only DHCP server in your local network.
  3. Check your phones' basic information, including phone manufacturer, MAC address, phone model.
  4. On your phones, enable DHCP function.
  5. On the PBX Settings > System > Security > Service, enable DHCP Server.
  6. On the PBX Auto Provisioning page, scan phones, all the detected phones will appear on the page.
  7. Edit or add phones, set your phones' manufacturer, MAC address, model.
  8. Set the phone lines.
  9. Set the phones' language and time.
  10. Optional: Set other phone settings.
  11. Save the settings and REBOOT your phones.
    Note:
    • If the phones do not reboot automatically, reboot the phone manually to make the configurations take effect.
    • After auto provisioned successfully, each time when your phones reboot, they will get and apply configurations (phonebook, language, time, etc.) from the PBX.