Connect Your PBX

Connect your PBX to the local network, and connect telephony lines to the PBX.

Connect P520

  1. Connect your PBX to the network.

    Connect one end of an Ethernet cable to the LAN port of your PBX, and the other end to any port of your company’s LAN switch/router.

  2. Power on your PBX.

    Plug the provided power adapter into the power inlet of the PBX, and the other end to a standard electrical wall socket.

    Wait for the system to boot up till the SYSTEM LED starts to blink.

  3. Connect your PBX to the telephony lines.
    Note: Connect BRI/PSTN/analog phone/fax machine to the corresponding port based on the color of port indicator.
    RJ11 Port Operation
    FXS

    Connect one end of a RJ11 phone cable to the port. Connect the other end to an analog phone or fax machine.

    FXO

    Connect an RJ11 cable to the FXO port. Connect the other end to a PSTN line.

    BRI

    Connect one end of the cable provided by the ISDN BRI provider to the BRI port. Connect the other end to the equipment of ISDN provider.

  4. Access the PBX system.
    1. Connect your computer to the same network as the PBX.
    2. Open a web browser, enter the PBX's default IP address 192.168.5.150 in the address bar, and press Enter.

      You will find the Installation Wizard appears.

      Note: For configuration details in the Installation Wizard, see Initial Setup Using the Installation Wizard.

Connect P550/P560/P570

  1. Connect your PBX to the network.

    Connect one end of an Ethernet cable to the LAN port of your PBX, and the other end to any port of your company’s LAN switch/router.

  2. Power on your PBX.

    Plug the provided power cord into the power inlet of the PBX, and the other end to a standard electrical wall socket.

    Wait for the system to boot up till the SYSTEM LED starts to blink.

  3. Connect your PBX to the telephony lines.
    Note: Connect BRI/PSTN/analog phone/fax machine to the corresponding port based on the color of port indicator.
    RJ11 Port Operation
    FXS

    Connect one end of a RJ11 phone cable to the port. Connect the other end to an analog phone or fax machine.

    FXO

    Connect an RJ11 cable to the FXO port. Connect the other end to a PSTN line.

    BRI

    Connect one end of the cable provided by the ISDN BRI provider to the BRI port. Connect the other end to the equipment of ISDN provider.

    E1/T1/J1 Port Operation
    E1/T1/J1
    Connect one end of the E1/T1/J1 cable to the E1/T1/J1 port. Connect the other end to the E1/T1/J1 Provider’s equipment.
    Note: The operation is ONLY available for P560 and P570.
  4. Change the PBX's default IP address via NFC to the same subnet as your computer, then access this new IP address from your computer.