Create a VoIP Trunk by a Template

If your VoIP trunk provider is tested and supported by Yeastar, you can create a VoIP trunk by a template.

Procedure

  1. Go to Settings > PBX > Trunks, click Add.
  2. In the Name field, enter a trunk name.
  3. From the Select Country drop down list, select the country that the VoIP provider operates in.
  4. From the ITSP drop down list, select the VoIP provider.

    The pre-configured template is applied for the selected VoIP provider.

  5. If your trunk is a Register Trunk, complete the following configurations:
    1. On the Basic page, configure the following settings:
      • Hostname/IP: Enter the IP address or the domain of the VoIP provider.
      • Domain: Enter the IP address or the domain of the VoIP provider.
      • User Name: Enter the username to register to the VoIP provider.
      • Password: Enter the password that is associated with the username.
      • Authentication Name: Enter the authentication name to register to the VoIP provider.
      • From User: Enter the same name as User Name.
    2. Configure DID settings for the trunk:

      To add signal DID:

      1. Select Add Signal DID.
      2. Enter the DID Number which is provided by the VoIP provider.
      3. Select the checkbox of DNIS Name, enter a DNIS name for the DID number.

        When users call the DID number, the DNIS name will be displayed on ringing phone.

      4. Click and repeat steps i-ii to add another DID numbers.

      To bulk add DIDs:

      1. Select Bulk Add DID.
      2. Enter the DID Number Range which is provided by the VoIP provider, click Add.
      3. Select the checkbox of DNIS Name, enter DNIS name for a DID number.

        When users call the DID number, the DNIS name will be displayed on ringing phone.

  6. If your trunk is a Peer Trunk, complete the following configurations:
    • Hostname/IP: Enter the IP address or the domain of the VoIP provider.
    • Domain: Enter the IP address or the domain of the VoIP provider.
  7. Configure other VoIP trunk settings as your need.
  8. Click Save and Apply.

    You can check the trunk status in PBX Monitor. If the trunk status shows , the trunk is ready for use.