Create a VoIP Peer Trunk - General

If your VoIP provider is not included in the supported VoIP provider list, and the ITSP only provides an IP address or domain for your purchased VoIP account, you can set up a Peer Trunk on the Yeastar Cloud PBX.

  1. Go to Settings > PBX > Trunks, click Add.
  2. In the Name field, enter a trunk name.
  3. In the Select Country drop-down list, select General.
  4. In the Trunk Type drop-down list, select a type of Peer trunk.
    Note: If you don't know which type to select, contact Yeastar support.
    Peer Trunk Type Description
    DID-based If the VoIP provider routes incoming calls and outgoing calls based on the DID number, select DID-based VoIP trunk.
    Port-based If the VoIP provider routes incoming calls and outgoing calls based on the SIP registration port, select Port-based VoIP trunk.
    Note: If this type is selected, a specific SIP registration port will be assigned to the PBX. In this way, the VoIP provide can correctly route the calls.
    Domain-based If the VoIP provider routes incoming calls and outgoing calls based on the PBX domain name, select Domain-based VoIP trunk.
    Private Network If the PBX and the VoIP provider are in the same private network, select Private-Network based VoIP trunk.
  5. Enter the trunk information that is provided by the VoIP provider.
    • Hostname/IP: Enter the IP address or the domain of the VoIP provider.
    • Domain: Enter the IP address or the domain of the VoIP provider.
  6. Configure other VoIP trunk settings as your need.
  7. Click Save and Apply.

    You can check the trunk status in PBX Monitor. If the trunk status shows , the trunk is ready for use.