Skip to content

Install Yeastar Visitor Screen DS7510

This topic describes the hardware overview of Yeastar Visitor Screen DS7510 and gives instructions on how to install, power on, and network a Yeastar Visitor Screen DS7510.

Package contents

Before you begin to install Yeastar Room Display, make sure all of the following items are included in the product package.


Yeastar Visitor Screen DS7510


Wall Mount Bracket


Wall Mount Screw Kits


VESA Screws


Adhesive Tapes


Optional: PoE Injector


Optional: VESA
Desktop Stand


Quick Installation Guide


Warranty Card

Hardware Overview

No. Description
Touch screen
Front LED light strip
Light sensor & distance sensor
NFC area
Back LED light strip
Wall mount hole
VESA 75*75mm
Type-C port
DC power jack
Ethernet port (PoE)


Install Visitor Screen DS7510

Tip

Yeastar Visitor Screen DS7510 is compatible with all 75*75 VESA mounts. You can install it on any VESA mount that meets the requirement.

1. Plug an Ethernet cable into the Ethernet port of the Room Display. Then lift the Room Display and align its VESA holes with the VESA desktop stand. 2. Fix the Room Display to the VESA desktop stand by tightening the VESA screws.

Power supply and network connection

Yeastar Visitor Screen DS7510 can be powered via a PoE injector, PoE switch, or a DC power adapter. Choose one of the following methods to power up the Visitor Screen and connect it to the Internet.

PoE injector power supply and network connection

  1. Powered by a PoE injector:

    1. Connect the Ethernet cable of the Visitor Screen to the Data+Power port of the PoE injector.
    2. Plug the power cable from PoE injector to a power outlet.

  2. Network connection: Choose one of the following methods to connect the device to the Internet.

    • Wireless network connection:

      1. After the Visitor Screen boots up, tap Configure the System Network on the screen.
      2. Enable Wi-Fi and connect the device to a Wi-Fi network.
      3. Tap the in the bottom bar to access the desktop.
      4. Swipe up the screen and select Visitor Kiosk.
    • Wired network connection: Plug an Ethernet cable into the DATA port of PoE injector and connect it to the switch.

PoE switch power supply and network connection

  1. Powered by a PoE switch: Connect the Ethernet cable of the Visitor Screen to a PoE switch.

  2. Network connection: Visitor Screens powered by a PoE switch are automatically connected to the Internet.

DC power adapter power supply and network connection

  1. Powered by a DC power adapter: Connect the DC power jack of the Visitor Screen and the power outlet with a DC power adapter(3.5 X 1.3 mm plug).

  2. Network connection: Choose one of the following methods to connect the device to the Internet.

    • Wireless network connection:

      1. After the Visitor Screen boots up, tap Configure the System Network on the screen.
      2. Enable Wi-Fi and connect the device to a Wi-Fi network.
      3. Tap the in the bottom bar to access the desktop.
      4. Swipe up the screen and select Visitor Kiosk.
    • Wired network connection: Connect the Ethernet cable of the Visitor Screen with a switch.

What to do next

After installation, you can register the Visitor Screen to Yeastar Workplace.


Last update: May 17, 2023
Created: September 16, 2022
Was this page helpful?