Auto Provision Yealink DECT Phones with Yeastar P-Series PBX System

This topic describes how to provision Yealink DECT base and DECT handsets with Yeastar P-Series PBX System in the local network.

Supported phone models

Check the supported devices and device firmwares in Auto Provisioning - Supported Devices.

This topic takes the following Yealink devices as an example:

Make sure that a DHCP Server is enabled in your local network to assign an IP address to the DECT base.

Power on PBX first, then power on the DECT base.
Log in to PBX web portal, go to Auto Provisioning > Phones.
The DECT base is detected.
Click to edit the desired DECT base.
1. In the Options section, select a desired template from the Template drop-down list.
2. In the Assign Extension section, assign an extension for the DECT handset.
3. Configure other settings according to your needs.
Click Save.
The handset is listed under the DECT base.

Click on the IP address beside the DECT base to log in to the DECT base web interface.
Go to Status > Handset & Voip to register the handset.
In the Register New Handsets section, click Start Register Handset.
Confirm registration on DECT handset.
1. On the handset, press OK > Settings > Registration > Register Handset > OK.
  The handset starts to search for a DECT base, and displays the MAC address of the detected DECT base.
2. Press OK.
  You are requested to enter the PIN of the DECT base.
3. Enter the PIN code, and press Done.
  
  Note: The default PIN is 0000. You can change the PIN on the DECT base web interface (Path: Security > Base PIN).
The handset prompts Handset Subscribed, indicating the handset is successfully registered.